if the value is below a reference value for more than x hours, then do something. Hello I have a question to the forum how you would approach it. I have the measured value, which comes from mqtt, written into a flow.set and compare this every few seconds with the latest value, if this is below my…

If you need it to survive a restart then use the persistent storage feature which retains context variables over a restart. Every time you get a good value update a persistent flow value with the current time. When you get a bad value check the time against that flow variable and if greater than two…

Colin 30 July 2022 19:49 5

1 Like

Topic		Replies	Views
Trigger output if value unchanged for X amount of time General	5	2385	5 August 2020
Suggested Approach please General	7	494	2 September 2018
Saving context - advice requested! FAQs	21	1503	18 July 2020
Best way to collect, store and retrieve a small (10-25) set of sensor values General	11	2897	9 April 2019
Looking for something to happen within a time range General	7	468	22 December 2019

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

If the value is below a reference value for more than x hours, then do something "fail-safe"

Related Topics