# 🎉 Node-RED 3.0.0-beta.2 released

**URL:** <https://discourse.nodered.org/t/node-red-3-0-0-beta-2-released/62698>\
**Category:** News\
**Created:** [16 May 2022 14:15 UTC](https://discourse.nodered.org/t/node-red-3-0-0-beta-2-released/62698 "2022-05-16T14:15:29Z")\
**Posts on this page:** 1\
**Showing post:** 21

<div class="post-metadata">

**Author:** ![Paul-Reed](https://sea2.discourse-cdn.com/flex026/user_avatar/discourse.nodered.org/paul-reed/32/66906_2.png) [@Paul-Reed](https://discourse.nodered.org/u/Paul-Reed)\
**Post date:** [17 May 2022 09:34 UTC](https://discourse.nodered.org/t/node-red-3-0-0-beta-2-released/62698/21 "2022-05-17T09:34:57Z")

</div>

> [@shrickus](#):
>
> the swipe is crossing right at the point where 2 wires cross

I don't think so, if you look at the dashed swipe track line, you'll see I curved it's path between the 2 crossed lines, but yes, maybe it was a little close.  
I think that the bigger problem is trying to perform a 'consistent speed' swipe using a touchpad, whilst holding down a touchpad button, and the keyboard combination at the same time. It isn't easy! and results in wires being missed because the cursor travelled too fast over a particular section of the swipe.  
But, not a big problem, lets leave it here, just need to be aware and double check afterwards, and if it's missed a wire, I can always Ctl-Z and try again 😀

---

_[View the full topic](https://discourse.nodered.org/t/node-red-3-0-0-beta-2-released/62698)._