I have setup four nodes using the RPI-GPIO-In nodes. I am aiming at storing alarms into Influxdb. If the GPIO is High the function output "1" if GPIO is low the function output a "0". The nodes work correctly when I inject the 0 or 1 from Nodered. It doesn't work when the real physical high happ…

We need to see the output when it fails. Also please connect the debug direct to the GPIO, as asked. Also disable all the all the other debug so only the one is seen. However, before you do that you need to add a pulldown resistor. As you have it the input is floating when you are not driving it…

Topic		Replies	Views
Rpi-gpio in node - always incorrect first read after boot General	19	1737	9 May 2020
GPIO is showing OK not the pin state General gpio	23	478	22 February 2025
Node Red RPi - GPIO in flow General	7	1212	16 November 2020
GPIOs not responding to input change General	20	353	30 June 2024
GPIO output fails "on"? Hardware	5	1468	20 May 2019

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

RPI-GPIO-IN not giving the expected output

Related topics