In Labview, Im used to basically drawing a line from the write to the input node of the USB read. There is not an input node on the USB read to control the flow. How do you read the response from the packet I sent? Here is my code: [{"id":"9a21f667.8fc0c8","type":"tab","label":"Flow 4","disabled":…

Try setting the serial config node to split on 0x03 & return a buffer [image] See if that give a more sensible response EDIT... And send a copy of the results once more & a description of what you believe the reply means (same as I asked before please)

Steve-Mcl 1 July 2020 21:49 12

Which debug is giving you replies? suspect it's the top one attached to the serial request & the 2nd serial in node isn't required.

And now you are getting data back, can you do the following?...

Topic		Replies	Views
Not able to read response from device on USB General	3	215	27 December 2022
Stuck using Serial Node General	23	1568	2 April 2020
Modbus RS485 read errors? General	9	143	31 May 2024
Read device by RS485 ASCII General	59	3678	2 June 2020
Serial data : how to split? General	8	183	30 September 2023

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

Have writing to a usb to RS-485 adapter working but how do I read back the response?

Related topics