hey guys, today my mqtt broker (eclipse-mosquitto) seems to flood my node-red at all. I have a couple of Shelly Plug S in my smarthome. They send multiple messages of their actual state like temperature/energy/relay state/power and so on. If I connect my mqtt broker node with any node that follows…

You have an MQTT loop, so something is subscribing to the topic and message goes through nodes and ends up publishing it again, which initiates a new message at the subscriber, etc. Often this is through a dashboard node where you have told it to pass input messages to the output. Stop the mqtt se…

Thank you for your answer. That could not be the issue. I never changed anything in past 2-3 weeks that belongs to my MQTT nodes! It started today at 9:48 am.... I even wasn't at home to change anything :frowning: Will take a 5th look at all my flows. Starting to think about that my Shellies or j…

Actually 1600 over 3 minutes is only 10/second, a pi should be able to handle 1000/second. Something else is going on.

MQTT Flooding Messages from Shelly

General

nicedevil 18 February 2020 18:30 5

Ah ok, I thought this will be too much right now

EDIT: Forget it... you were right! The test switch wasn't configured right.... that was connected the one not connected shelly that is laying around... I didn't take a look at this on my debug trys (because it wasn't in use)....

Now it seems to be fixed

Topic		Replies	Views
Mqtt takes up to 5 seconds General	5	483	14 March 2021
MQTT 'Connection failed to broker' General	13	2499	20 December 2022
Multiple MQTT nodes affect eachother General mqtt	3	237	27 August 2022
Mqtt-in repeated messages bug? General	16	2891	30 March 2019
Shelly integration & MQTT (via MacBook) General mqtt , shelly	12	187	23 April 2025

MQTT Flooding Messages from Shelly

Related topics