Hi folks, I am new to Node RED and MQTT, I would like to know how to use Raspberry pi UART (ttyS0) in Node Red, I mean which block I have to use it. Help me please Kind Regards George

The serial port node is what you need though not sure if pi has ttyS0 by default. The built in one is ttyAMA0 if enabled I thonk

Node-RED

Node-RED Forum

Raspberry Pi UART

General

georgethomas08 11 July 2019 17:59 3

Thanks for the support, I am using raspberry Pi 3 b+, in that ttyAMA0 is connected with Bluetooth BLE, so the gpio pins 14 and 15 is ttyS0.

Topic		Replies	Views
UART port issue General	6	2160	10 May 2020
UART, I2C, SPI in node-red General	9	1572	24 December 2021
Raspberry Pi Serial General	1	1083	17 November 2018
Best way to connect multiple serial UART sensors to Node-Red? General	2	1597	28 October 2020
Rasperry Pi 4 Serial port RX issue Forum Help	2	869	18 June 2021

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

Raspberry Pi UART

Related topics