Hi. I have node red on Edge Device. The node red runs on docker. I have camera connected to the same network (able to ping the cam fine). Using node-red-contrib-onvif snapshot node, I was able to get a capture. My settings is as follows: [onvif] Using same settings on node-red-contrib-onvif-no…

So, I tried again your suggestion by just supplying the IP (without port and paths), but it still isn't working. I have found another way though - using the ISAPI protocol on the camera (using standard HTTP REST requests) and can work. Anyways, thanks for your comments and replies.

Hello! I summon @BartButenaers and other folks to help. Lately, i tried to install Bart's nodes https://github.com/bartbutenaers/node-red-contrib-onvif-nodes first, i tried command npm install node-red-contrib-onvif-nodes@0.0.1-beta.7 from manual https://github.com/bartbutenaers/node-red-contrib-…

To install like that you need git installed. sudo apt install git

[image] Colin: you need git installed Hey Colin, thanks for your help. I had asked @greyser to ask his question on Discourse, because there are smart people in the community... So "spawn git ENOENT" means git is not installed. I should remember that!

@Colin @BartButenaers thanks, guys. I will try to install git an first

Yes, apparently it is short for Error No Entry (or Entity). It is a linux system error code.

@BartButenaers @Colin Thanks, I installed nodes. Now I m trying to connect to my cameras. Discovery node shows 2 of 3. Made 3 configurations for each camera, insert IP and port from Discovery Xaddr , but cant connect. [image] [image] [image]

In the field "IP address" you should only enter the IP address: [image] [image] greyser: Discovery node shows 2 of 3. So you have 3 ip camera, but only 2 are discovered? Correct? Is that third camera another brand? You could try to increase the "Timeout" value in the discovery node, so c…

Bart, thanks. Entered just IP, got errors [image] [image]

I should not use "http://" in an address form. Now it works

@BartButenaers Hello, again! Now I try send "goto PTZ preset" command. First, i got names of all presets by GetPresets action, then insert one value to presetName. But camera not responding anything. Am I doing everything right? [image]

Node-RED

Node-RED Forum

Onvif VS onvif-nodes issue

General

SuperNinja 18 September 2020 17:21 24

yes i will

ouch ! hope it will be not serious !

Node-red-contrib-onvif-nodes : Beta test

Topic		Replies	Views
Onvif camera control General	114	21643	9 May 2020
Node-red-contrib-onvif-nodes macOS General	61	2662	15 September 2021
Onvif-nodes v0.0.1-beta 15 issue General	1	362	11 November 2021
[ANNOUNCE] node-red-contrib-onvif-nodes (beta 7 : event streaming) Share Your Nodes	23	3873	26 March 2020
IP camera - install onvif package General	5	527	27 June 2025

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

Onvif VS onvif-nodes issue

Related topics