Hi, I need some advice or direction. I have a device that has 100 inputs and communicates via UDP. According to certain parameters in the packet I want to route to a specific output using the switch function. I'm trying to set a condition for a value in a buffer, but I can't find the right shape. …

Try payload."0" etc instead of `payload[0]

put a debug node after the buffer and see what comes out for msg.payload and msg.payload2 this may clear up what you are looking for

I tried that, of course. It's the same thing that goes through the switch and I didn't find anything new. Array working, buffer not working. [debug]

Node-RED

Node-RED Forum

Switch node and buffer

General

Colin 13 November 2021 10:14 6

If anyone is insterested, then see this post for more information Weird JSONata problem

Topic		Replies	Views
[Feature Request]Add ability to use buffer type in switch node Feature Requests	10	204	2 December 2023
Switch node with HEX input General	7	2951	19 December 2019
Help switching bytes from buffer General	4	91	28 March 2026
How to check if a value is in array using the switch node General	3	248	7 March 2023
Send different values from an array to different nodes? General	3	200	1 May 2023

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

Switch node and buffer

Related topics