Continuing the discussion from Arduino i2c Firmata : Is there any way to connect Arduino NANO boards to handle I/O + Analog (+ I2C ?) through NodeRed? Important: NANO has ONLY a USB port! ... so most of the MQTT libraries based on Wi-Fi chips will not work. Has anyone done this before? I'm not l…

PizzaProgram 11 December 2020 13:58 3

YES, this is exactly the thing I'm looking for!

with minimal C, only "forwarding" RAW data from/to all ports and reconnecting if connection lost.
doing whatever possible at NodeRed side.

My question is:

HOW to do that?

Currently I'm investigating this:

And This:

Arduino USB > Firmata > I2C > [GPIO PCF8574 + MCP23017 + temp BMP280]

Topic		Replies	Views
Node-red communicating with Arduino using MQTT and NO Wifi? General	2	1032	12 September 2019
Help/ point in the right direction General	4	235	22 July 2021
Running arduino code on raspberry inside Node-RED General	6	1645	16 May 2019
Arduino i2c Firmata Developing Nodes	18	2791	10 December 2020
Reading Arduino serial data into node red via usb General	8	1505	23 April 2021

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

MQTT with Arduino Nano + NodeRed

Related Topics