Hello everyone,
I have (maybe stupid) question:
I have Raspberry Pi3, GrovePi+ board, Grove - I2C Hub and two sensors.
GrovePi+ board is connected to Raspberry Pi3.
Grove - I2C Hub is connected to GrovePi+ board via I2C (port 1).
main question is: which node (in Node-RED) I have to use for reading values from both sensors separatly?
Thank you very much
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.
Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.
The OpenJS Foundation | Terms of Use | Privacy Policy | OpenJS Foundation Bylaws | Trademark Policy | Trademark List | Cookie Policy
