Hello, I have two MCP3008 and would like to read them out via Node-Red. My problem is that I can only read it out for one Device ID. If I set the first A/D-Converter to CE0, the second A/D-Converter also use CE0, although it is set to CE1. Is it possible to use both Device IDs? I have installed: n…

Thank you for your answer. I tried to use the SPI1 bus for the second A/D-Converter, but I have the same result. My properties: For the first mcp3008: Device: mcp3008 Input pin: A6 Device ID: CE1 SPI Bus: 0 For the second MCP3008 Device: mcp3008 Input pin: A6 Device ID: CE0 SPI Bus: 1 Fo…

Node-RED

Node-RED Forum

Use both MCP3008 Device IDs

General

edje11 2 November 2020 11:27 2

Maybe this topic can help you; Use SPI1 in Node-RED

Topic		Replies	Views
Problems with more than one MCP3008 General	12	1164	26 July 2021
MCP3008 SPI chip select on Node-RED General	0	948	25 September 2018
How get or red output from adc mcp3008 in node red General	15	1441	6 February 2022
Use SPI1 in Node-RED Developing Nodes	4	860	21 September 2018
Node-red-node-pi-mcp3008 always return 0 General	1	1059	2 June 2018

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

Use both MCP3008 Device IDs

Related topics