Anyone try this board and attempt to read/control GPIO pins?
It's the $35 board currently abundantly available.
It runs NR fine, but so far, I can't get it to do anything with the pins other than exec commands to read/set by the Libre Computing Wiring Tool (but not assign pullup/pulldown, so they drift/float in state).
I was hoping to get an overlay applied to the Raspberry pi nodes work with this board. Anyone figure that out yet?
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.
Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.
The OpenJS Foundation | Terms of Use | Privacy Policy | OpenJS Foundation Bylaws | Trademark Policy | Trademark List | Cookie Policy