Hi folks, Winter is coming, which means my wife will ask again when I will have room temperature control ready: for example when she enters the bathroom at 07:00 in the morning, the room shouldn't be heated. I can't count anymore how much years in sequence she has asked me that same question. It …

Yep. I have been reading about that this morning. I love the look of it. Just sad it can’t take power from Ethernet, and as far as I’m aware nobody has hacked it yet to access the Nextion screen built in

A) Welink is a nogo (asks for full location gps data on setup - sorry, thanks no) But the esp32 is fully exposed via “normal” pin headers. I like the two physical switches and build in relays and temp sensor (but I would have preferred a better one) B) yes but the height of a light switch is not …

Yes it is a Nextion - iTead Studios have published the spec

An esp32 only for wifi and all the alexa and google stuff? Oh no. I did some nextion test a few years ago and it was awful. Not only the editor but also the result was not appealing. If you need something like this the wireless tag 8ms software looks promising. Based on the LVGL library http://do…

d) it seems to lag :stuck_out_tongue:

Have a look new little touch terminal more info

Hi @juntiedt , Yes the Sonoff NSPanel seems like a nice device: [image] And it has a temperature sensor inside. But for my use case it lacks some features: It is an in-wall solution (to replace a traditional light switch): [image] No PIR sensor. Fixed dashboard, e.g. swipe to show temp…

As far I know by now the screen is produced by nextion and communicates via serial to the esp32 handling wifi and all the alexa, google …. Nextions use stm32 (good choice for tfts). Handling with two different platforms makes the hardware less attractive to open source project. The nextion editor …

BTW a pir sensor is not necessary. Espressive found a way to do that in software analysing the wifi data [ESP-WIFI-CSI: Espressif's Human-Detection Solution]

Many Sonoffs can fairly easily be reflashed with Arduino code, and I think there is an LVGL Arduino library. Don't know if it is open source, or even if it works.

Node-RED

Node-RED Forum

Wall mounted Node-RED touch screen device: Request for ideas and volunteers

Hardware

Christian-Me 17 October 2021 07:47 160

Sure: New bathroom ideas - #91 by TotallyInformation

Topic		Replies	Views
Best touch screen to use with NR dashboard? General	28	6484	3 November 2020
A small wall mount PI Zero with touch screen Hardware	47	3634	22 February 2021
New Shelly wall display (and alternatives?) Hardware	52	3772	22 November 2023
Making a Dashboard for the 7 inch TFT display Dashboard	30	4866	14 June 2020
Temperatures in Pizzeria freezers :cold_face: General	49	784	24 September 2025

Copyright OpenJS Foundation and Node-RED contributors. All rights reserved. The OpenJS Foundation has registered trademarks and uses trademarks. For a list of trademarks of the OpenJS Foundation, please see our Trademark Policy and Trademark List. Trademarks and logos not indicated on the list of OpenJS Foundation trademarks are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

Wall mounted Node-RED touch screen device: Request for ideas and volunteers

Related topics